SWP-HCI U-SIM
SWP/HCI test tool for U-SIM is validated by Global Platform, and performs all test cases (electrical and protocol) ETSI102.695-2 and ETSI 102694-2
Use Cases
This solution will typically be used in the following contexts :
- debug of the SWP interface of a U-SIM
- debug of the HCI stack of a U-SIM
- conformance testing
What is SWP-HCI U-SIM ?
On top of the MP300 TC3, allowing to perform electrical and protocol test of SWP enabled U-SIM, we propose a test library. Following the requirement of the ETSI (ETSI TS 102 694-2 (SWP) and ETSI TS 102 695-2 (HCI)). This solution is validated by Global Platform. SWP (Single Wire Protocol) is the communication protocol between the mobile handset and the UICC. It enables the NFC application to reside on the U-ICC. The HCI (Host Controller Interface) provides a logical interface on top of the SWP to support the creation of a host network and support contactless applications on the U-ICC What we propose, is a test platform that allows to simulate a CLF, and therefore test the good behaviour of the U-SIM following the test methods defined in the ETSI specifications ETSI TS 102 694-2 (SWP) and ETSI TS 102 695-2 (HCI). The main features of this SWP/HCI test library for U-SIM are :- Test of a U-SIM according to the standards ETSI TS 102 694-2 (SWP) and ETSI TS 102 695-2 (HCI)
- Fully automated generation of test reports
- Automated test sessions
- Test cases validated by the GCF, PTCRB, and GlobalPlatform
- Solution widely deployed at validation laboratories
Technical Data
The test session happens in a very simple manner.
First, the user inserts the U-SIM card inside the MP300 TC3.
Then, the user starts the software test tool, selects which test cases he wants to play.
Finally, the user collects the test results, generates test reports, and analyses the failures
Hardware platform :
Test case coverage : 100% of the ETSI TS 102 694-2 (SWP) and ETSI TS 102 695-2 (HCI) test specifications
Related products
MP300 TC3
High end tester, for contact smartcards and contact based secure elements. Support of ISO 7816, SWP/HCI, USB 2.0, USB-IC and I2C protocols. Immense flexibility in terms of physical and protocol […]
Related accessories
MPManager 3
All MP300 and MP500 devices come supplied with the MPManager user interface. The job of MPManager is to give access to all of the functionalities of your tester, in an […]
FLYING PROBES ADAPTOR
This adaptor allows to connect our contact testers to devices that have not the typical smartcard or SIM form factor. But that are located for example on PCB, such as M2M […]
MP-ESC (EXTERNAL SMARTCARD READER)
This external smartcard reader is typically connected to a tester using a MDR14-MDR14 cable, and facilitates for example test of contact smartcards in climatic chambers.
MEASUREMENT PROBE
It might be interesting to monitor using an oscilloscope the different signals that are part of an ISO 7816 , or SWP communication for a better analysis. This measurement probe […]